Stens OEM Replacement Belt Husqvarna 584216101. Belt Application: Auger drive. Belt Type: Raw edge. Packaging Type: Branded sleeve. The item “Replacement Belt For Husqvarna ST224 & ST227P Snowblowers, 2005-2015 / USA Made” is in sale since Wednesday, July 26, 2017. This item is in the category “Home & Garden\Yard, Garden & Outdoor Living\Outdoor Power Equipment\Snow Blowers”. The seller is “aasmallengineparts” and is located in North Bend, Pennsylvania. This item can be shipped to United States.
Aluminum Cargo Carrier with Ramp. Model # 528 ACCTG. This listing is for the carrier only. This high quality, economical carrier is ideal for transporting heavy equipment. You now have the ability to easily transport equipment or electric wheelchairs/scooters with a Sport Utility Vehicle, or any other vehicle that has a class 3 or class 4 trailer hitch. When loading onto this. Low to the ground carrier. As opposed to loading equipment into a high pick-up truck bed, or trying to wrestle the equipment into the back of a SUV (if there is room). With the built-in ramp the operation is fairly simple. The ramp is bolted on and lays in the carrier when not in use. When needed lift the. And deploy it to the ground as it pivots on two bolts. After loading the equipment raise the ramp to an upright position and then hold it in place with a provided hitch pin and already installed bracket. This carrier also gives you the option to change the side the ramp opens on. The tube that goes into the receiver bolts onto the carrier so if you switch sides (the receiver tube sticks out the opposite end) the gate will then deploy on the drivers side. Another advantage to the bolt on receiver tube is if you bent the tube from an accident you can easily replace it. Lightweight all aluminum construction. The 60″ long x 28″ wide carrier has a 2″ x 3″ x 3/16 thick angle frame. 2″ square tube (used for attaching to the vehicle) sticks out 8″ from the frame and is received by a class 3 or class 4 trailer hitch. The carrier’s expanded metal floor is reinforced with six – 1″ x 1″ square tubing. The ramp is surfaced with anti-slip expanded metal and reinforced with six 1″ wide x 1-1/2″ deep tubing. A wear plate is welded to the bottom of the ramp providing additional reinforcement. Total weight is only 56 lbs. Weight capacity (very conservative). This durable aluminum cargo carrier will not rust or ever need painting. Please note: anything that goes into a receiver hitch will have a little play. What you can do to eliminate the play (not really necessary though) is to tie down the equipment to the bumper on the inside (side closest to vehicle), and directly to the outside of the carrier at the opposite side (side furthest from the vehicle). The item “Cargo Carrier withRamp 28 x 60 USA For Loading Snowblowers and Wheelchairs” is in sale since Wednesday, September 21, 2016. This item is in the category “Home & Garden\Yard, Garden & Outdoor Living\Outdoor Power Equipment\Snow Blowers”. The seller is “mackieenterprises” and is located in Clementon, New Jersey. This item can be shipped to United States.
Recent Comments