1988 Craftsman 420 Trac Plus Snowblower Auger Impeller Assembly OEM Good Shape
Here’s a complete auger/impeller assembly from a 1988 Sears Craftsman 4/20 snowblower. The assembly is in good structural condition. This assembly fits many similar era Craftsman and Noma 24 blower models as well. The assembly is in good usable shape. These could be susceptible to brutal rust, collision damage, rock ingestion, or extreme wear. This assembly did see some normal wear over the years, but the nice rake spirals scoop the snow smoothly into the very nice impeller. The impeller vanes show some light debris contact, but are not folded back like so many. The augers still slide on and off the auger shaft cleanly and allow for a tight rotation. It spins out well, but will be ready for an annual gear box lubing. Included is the good sheave pulley, rear bearing, and auger bushings, that also still spin out pretty well. This assembly still worked good on the blower. They show some normal surface wear, but are pretty heavy duty. These little 420′s were very well built and could move a lot of snow on a smaller job. You are getting everything you see in the pictures. This assembly is still very usable for one of these famous ol’ Craftsman blowers! The Noma built blowers could really move a lot of snow back in the day–and still can! Great for spares too when one is needed in a pinch! These complete assemblies are getting very difficult to find in usable shape anymore. Thoroughly clean and lube prior to operation. Please look at the pictures. Ask any questions that you might have.
Recent Comments