Toro Snow Blower Engine Suzuki Ccr 2000 Good Used Engine
MOST ALL OF THE PARTS ARE THERE CARB- PULL START ASSEMBLY FLY WHEEL ETC – COIL – IGNITION MODULE.
MOST ALL OF THE PARTS ARE THERE CARB- PULL START ASSEMBLY FLY WHEEL ETC – COIL – IGNITION MODULE.
Here’s a complete auger/impeller assembly from a 1988 Sears Craftsman 4/20 snowblower. The assembly is in good structural condition. This assembly fits many similar era Craftsman and Noma 24 blower models as well. The assembly is in good usable shape. These could be susceptible to brutal rust, collision damage, rock ingestion, or extreme wear. This assembly did see some normal wear over the years, but the nice rake spirals scoop the snow smoothly into the very nice impeller. The impeller vanes show some light debris contact, but are not folded back like so many. The augers still slide on and off the auger shaft cleanly and allow for a tight rotation. It spins out well, but will be ready for an annual gear box lubing. Included is the good sheave pulley, rear bearing, and auger bushings, that also still spin out pretty well. This assembly still worked good on the blower. They show some normal surface wear, but are pretty heavy duty. These little 420′s were very well built and could move a lot of snow on a smaller job. You are getting everything you see in the pictures. This assembly is still very usable for one of these famous ol’ Craftsman blowers! The Noma built blowers could really move a lot of snow back in the day–and still can! Great for spares too when one is needed in a pinch! These complete assemblies are getting very difficult to find in usable shape anymore. Thoroughly clean and lube prior to operation. Please look at the pictures. Ask any questions that you might have.
This is a USED. It is as pictured here. This equipment was removed from a working environment and is in good operating condition when removed from service. The feedback of my Customers is very important to me and I encourage you to leave Honest Feedback. 65 lps, 19″x19″x19 from 44146. Recommended for Snow Blower.
I didnt have time to mess with this one, so I have decided to start pulling motors and sending them out to better homes. Cool little bronze coated 2 cycle motor. Out of Toro snow thrower. Hasnt run in years but turns over by pull. Ignition panel and mounting hardware is included.
Snow blower is a 2 cycle 50:1 fuel oil ratio. It ran well just before I listed it a couple of months ago. I have not run it recently. I can video it running before packing it up to send. Thank you for looking.
Snow blower works good. This item is in the category “Home & Garden\Yard, Garden & Outdoor Living\Outdoor Power Equipment\Snow Blowers”. The seller is “partman4545″ and is located in this country: US. This item can be shipped to United States.
Snow blower is a 2 cycle 50:1 fuel oil ratio. It ran well when I tested it several years ago. I have not run it recently. Thank you for looking. This item is in the category “Home & Garden\Yard, Garden & Outdoor Living\Outdoor Power Equipment\Snow Blowers”. The seller is “wwdan” and is located in this country: US. This item can be shipped to United States.
CRAFTSMAN 10hp TECUMSEH HORIZONTAL SHAFT ENGINE Good Running. This item is in the category “Home & Garden\Yard, Garden & Outdoor Living\Outdoor Power Equipment\Snow Blowers”. The seller is “partman4545″ and is located in this country: US. This item can be shipped to United States.
THANK YOU FOR LOOKING AT MY PARTS. This item is in the category “Home & Garden\Yard, Garden & Outdoor Living\Outdoor Power Equipment\Snow Blowers”. The seller is “miller-wilber” and is located in this country: US. This item can be shipped to United States.
Recent Comments